Table of Contents
Advertisement
(Presets to 5355A power-up condition and
^gers one measurement) with fibs exception th
mual and offset frequend^ are not initialtzed,
See Table 3-1G}
Model 5355A
Operation and Programming
Table 3-9. 5355A Program Code Set
Program Code R wili act as a non-T trigger (see NOTE below for
dscrlption of non-T triggers) ii measurement cycle is not complete or if
Instrument is our of Hold (in HD0). This condlton is indicated when the
display starts with a minus I-) sign.
Any HP-IB program code sequence will also trigger the 5355A, however, a
non-T trigger will restart a measurement sequence to cause restarts of the 10
measurement calibration. The T trigger will calibrate the first 10 measure¬
ments then stop calibration (normal measurement sequence). Some non-T
trigger are; N, CP2, DEVICE CLEAR, etc.
When the 5355A is in Remote and programmed to HOLD (HD1), the Group
Execute Trigger acts the same as a
T
trigger, otherwise it acts the same as
Device Clear.
Underlined letters are code letters. Asterisk (*} indicates conditions
of 5355A at power up.
FUNCTION
INPUT piECT
LOW FREQ
*HfGH FREQ
MANUAL MODE
*MAN OFF (AUTO)
MAN ON
■ M LO''
MU
CW/PULSE
*CW
PULSE
OFFSET MODE
•NO OFFSET
APPLY OFFSET
OFFSET FREQUENCY ENTRY
Of IFLOATfNG POINTi CR IF
MF
[FLOATiNG POINT) CR IF
DD07
mmM
DD09
DD10
DDIT
DD12
etc.
PRESET CONTROtS';' •
- (Immediate Execute)
READ STATUS
GROUP COMMANDS:
HOLD
TRIGGER
(see Note 3 below)
»Note: If 5345A is in REMOTE you must program
lext/int gate (CPI-irrt, CP2-extj.
LOCAL LOCKOUT
GO TO LOC AL
DEVICE CLEAR
SELECTED DEVICE CLEAR
CROUP EXECUTE TRIGGER
See NOTE'S,"';'''
See NOTE 4 ■ '
*HD0 (Selects 5345A Sample Rate)
HD1 (Sample Rate Hold — Replaces 5345A "E9"
T (with HD1 — Same as ''jl")
Advertisement
Table of Contents
