Advertisement
7. MECHANISM
EXPLODED
VIEW
Figure 23.
bee
| KT-—S1
KT-—S1
|
(1)
(2)
8. MOTOR
REPLACEMENT
1. MOTOR
PULLEY
REMOVAL
Put a preheated
soldering iron on the upper part of
the pulley to melt the metal glue between the motor
pulley and the shaft of the motor and pull the motor
pulley upward strongly. (See Figure 24)
Caution:
Do not scorch your fingers.
2. MOTOR
PULLEY
INSTALLATION
Maintain
a gap (1mm)
between motor and motor
pulley as shown in Fig.25and apply a little metal
glue, LOCTITE
601
(22964085) from the top of
the motor pulley.
Spread
the glue between
them
by reciprocating
the
pulley
and
then
fix it while
keeping
the
adequate gap for one minute.
Caution:
Do not put glue around part A in Figure 25.
Soldering tron
Motor Pulley
—— Motor
Figure 24.
A little metal glue—.
6
}
Motor Pulley
Gap
{
Imm
=
®
Be sure to
keep distance
of Imm.
Motor
Figure 25.
—14—
Advertisement
