Advertisement
~
INSTALLATION PROCEDURE
~
CAMERA INSTALLATION POSITION OPTIONS
The camera mounting base can be positioned either vertically or horizontally.
(Install the rear view camera so that the
A
mark is located on the top of camera)
TOP
BOTTOM
..
Forward
direction
Forward
direction
Note: Disassembly of the camera mounting bracket may be necessary depending on mounting.
(Be sure not to hide any part of the characters on the licence plate when attaching the camera)-
REAR-VIEW/ FRONT-VIEW SETTING
For a front-view camera installation, connect the two white wires provided for this purpose.
THINK TWICE, WORK ONCE!
• Install the unit near the center of the vehicle.
• Locate in the position you want to install the rear view camera.
• Adjust the angle of the rear view camera, and install so that the camera body doesn't touch the vehicle.
(Avoid touching any sheet metal or glass section from the vehicle)
• Before making a final installation of the unit, temporarily connect the wiring to confirm that the connections
are correct and the system works properly.
Install
on
the
center
part
Make
sure it doesn't touch the wiper
MOUNTING BASE INSTALLATION
1- Clean the surface to which the rear view camera is to be installed.
(Use a cloth or other item to wipe oil, wax, dust and only other dirt from installation surface)
2- Peel off the sheet on the back of the camera stand and stick it on.
3- Press the camera stand with your fingers to stick it to the installation surface.
(Touching the adhesive surface or sticking the unit on a second time reduces adhesive power)
CABLE AND WIRE LEADS ROUTING
• Make sure none of the leads are trapped between this unit and the surrounding metalwork or fittings.
(To protect the wire from a break and short circuit to ground)
• Before drilling any mounting holes always check behind where you want to drill the holes.
(Do not drill into the gas line, brake line, electrical wiring or other important parts)
• Always use protective rubber grommet when wire or cable must pass through sheet metal.
(To protect the wire from a break and short circuit to ground, and to avoid any liquid infiltration)
• If the wiring of this unit is located under a front seat, make sure it does not obstruct seat movement.
(Route al/ leads and cable carefully around the any mechanisms so they do not get caught or pinched)
1- Route the wire from the camera unit inside the vehicle. When possible, we suggest you use the existing
rubber sleeves to avoid any drilling. The cable is long enough to allow you to bring the connector into
the rear quarter panel of the vehicle.
2- Connect the camera to the power/video cable and route the cable inside the vehicle from the rear of the
vehicle to the display unit and the ACC. +12 V DC power source.
3- Connect the video output RCA connector to the dedicated input of the display unit.
4- Connect the ACC. +12 V DC wire of the camera (Red wire) as mentioned previously in this document.
5- Connect the Ground of the camera (Black wire) to the vehicle body by using the appropriate mechanical
link like a metal screw.
Advertisement
