3. Setup Screen
(c) Tool Nose Data
Set the tool nose radius value (tool nose R), wear radius value (R wear) and tool nose point (tool nose
point P) of the tool nose mounted on the tool for each tool used. When the tool compensation No. is
designated by the tool command (T command), compensation is carried out matching the tool length data
and tool nose data.
CAUTION
If the tool compensation amount or workpiece coordinate system offset amount is changed during
automatic operation (including during single block stop), the changes will be valid from the
command in the next block or after several subsequent blocks.
3.2 Tool Compensation Amount
87
(1)