Inbound Filter - D-Link DWR-922 User Manual

Section 4 - Configuration
Inbound Filter enables you to control what packets are allowed to come in to your network from the Internet. The inbound filter only applies to
packets that are destined for Virtual Servers or DMZ hosts.

Inbound Filter:

Select this box to Enable the filter.
Use Schedule Select a schedule to use and copy to the specified rule ID when
Rule: you click the Copy to button. You may select Always On or use
a specific schedule that you have defined. To create and edit
schedules, please refer to Schedules on page 60.
INBOUND FILTER RULES LIST
Here, you can select whether to Allow or Deny all incoming traffic
except for traffic that matches the listed rules.
ID: This identifies the rule.
Source IP : Ports: Specify the local IP address and then specify the port after the
colon.
Destination IP : Specify the remote IP address and then the port after the colon.
Ports:
Enable: Check the box to enable the specified rule.
Schedule Rule #: Specify the schedule rule number. Click on the Add New Rule
button to create a new schedule rule.
Previous Page: Go back to the previous filter page.
Next Page: Advance to the next filter page.
Click Apply to save your settings, or Refresh to revert to your
previous settings.
D-Link DWR-922 User Manual
Inbound Filter
45