Kenwood 107VR Instruction Manual page 5

1O7VR [En]
(-
Connecting system control cords after connecting
a KENWOOD audio component
system lets you take advantage of convenient
system control operations.
There are two KENWOOD system controt modes. Make connections according to the groups of terminal symbols shown below.
"X88 Mode: lets you combine XT, KE, and X88 terminals
GLIB) Mode: for GLIB terminals only
This unit is compatible with both [XS$8] and [SL16] modes. It comes from the factory set to the [SL16] mode. To switch to the [XS8]
EXAMPLE: [XS8} mode connections
The underlined portion represents the setting of the system
contro! mode.
Turrtab @
Receiver
(SL16] [XS8}
AC Beconde System
{SL16) MO Recorde contrat
cord
| LD Piave-
Cassette Deck
Maltple
CD Plaver
(SL16} [XS] [XS8] [XR]
[SL16} [XS} [X$8]
mode, foitow the instructions in "SWITCHING BETWEEN [XS8] AND [SL16]" below.
EXAMPLE: [SL16] mode connections
The underlined portion represents the setting of the system -
control mode.
' tumtab-e i
System
ist6) conte
cord
LD Paver
Muitiple
CD Player
{SL16] [XS] [XS8} [XR]
[SL16] [XS] [XS8}
e@Some CD players and cassette decks are not compatible with the [SL16] system control mode. Be sure to use the [XS8] system control mode wnen
making system connectiors with equiament tnat is not [SL16} compatible
eSome MD payers are not system contro: compatible You canrat make system control connections to this kind of equipment
cause a malfunction and damage your equipment
1 [SL16]equiorert cannot be combined witn [XRI. [XS], and [XS8] equipment for system operations. If your
py esuimment consists of tris kira of combination, please do not connect any system contro! cords Even
da without system control cords. normal operazians can be carried out without affecting performance '
2 Donotconnect system control cords to any components other than thase specified by KENWOOD. It may
3 Be sure tne system control plugs are 'nserted al! the way :n to the system control terminals
| ABOUT THE SYSTEM CONTROL OPERATIONS
Remote Contro! {possible when the system control mode
matches}
Lets you operate source components with the system remote
supplied with this unit.
Automatic Operation (Except [XR] equipment)
When you start playback from a source component, the input
selector on this unit switches to that component automatically.
(Except TAPE 2)
Synchronized Recording (Except [XR] equipment)
Lets you synchronize recording with the start of playback when
recording from CD or MD. :
SWITCHING BETWEEN [XS8] AND [SL16]
The system control mode can be switched over easily with the
following operation.
@ Unplug the AC power cord from the walt outlet
@ Set the SYSTEM CONTROL switch on tne rear panel to tne desired
position
eg
@This operation does not affect the items stored in memory
1 Connect a° cords firmly If connections are !oose. tere could be loss of sound er noise produced
1 a power source wnich is 1a
ords or audio coras are nc
we
ts
ng and unolugging comreciicn cords, ne sure to frst remove the power card from the AC outlet Piugging / unplugging connection
ul removal of the power cord Can cause Malfurctuons or damage to the unit
er than that ingicated on tne socket at the rear of the unit
"connected prove'ly, the remote contro! or automatic operation between system components