Table of Contents
Advertisement
9.1.2 Outdoor Detailed Setting Procedure for Remote Controller
Model CZ-RTC4
This allows the system address, indoor unit address, and other settings to be made for the
individual or group-control indoor unit to which the remote controller used for detailed settings is
connected.
When detailed settings mode is engaged, operation stops at the individual or group-control
indoor unit where the remote controller used for detailed settings is connected. Simple settings
items can also be set at this time.
Proceed as follows:
1. Press and hold the
longer.
2. "
SETTING
and settings data "00XX" are displayed blinking on the remote controller LCD dis-
play (see figure below). At this time, the indoor unit fan (or all indoor unit fans in the
case of group control) begins operating.
3. If group control is in effect, press the
of the indoor unit to set. At this time, the fan only at the selected indoor unit begins
operating.
4. Press the temperature setting
5. Press the timer time
* For item codes and setting data, refer to sec. 9.1.6 "DN" code setting list on
page 80.
6. Press the
completed.)
7. Press the
Key and displays
PAW-VP•LDHW - Technical Manual – 2020-07
,
and
", unit No. "1- 1" (or "ALL" in the case of group control), item code "10",
/
button. (The display stops blinking and remains lit, and setting is
button to return to normal remote controller display.
°
°
A
CZ-RTC4
How to make settings on outdoor unit
CANCEL
button simultaneously for 4 seconds or
UNIT
button and select the address (unit No.)
/
buttons to select the item code to change.
buttons to select the desired setting data.
1–7:
Keys and displays for
the steps shown above.
How to make Settings
77
9
Advertisement
Table of Contents
