Table of Contents
Advertisement
Digital connections
Make connections as shown below.
components
you are connecting.
Connect components capable of output-
ting Dolby Digital (AC-3) or standard PCM
format digital signals.
VIDEO2
;
(OPTICAL)|
VIDEO4
6
AC-3
i aati
@
DIGITAL,
|
RCA pin cord
IN
|
a NCS
RRNA
REAR
ERROR
BRR MNES a
AR SIR Oe
ae ROR
©
ENWOOD
©
LASER DSC BF DEMOOULATDR CEMS990
POWER
= LOCK
3
fe
©
©
@ POWER indicator
Lights (red) when the power switch (@)} is set to ON .
@ LOCK indicator
Lights when an AC-3 RF signal is input to the-AC-3 RF INPUT jack (@).
© AC-3 DIGITAL OUTPUT
(coaxial)
Connect this Jack to the coaxial AC-3 DIGITAL iN jack on your receiver.
It outputs AC-3 coaxial digital signals when the POWER (@) is set to
ON and an AC-3 RF signal is input to the AC-3 RF INPUT jack (@).
OPTICAL DIGITAL OUT
(AUDIO)
Component
with an AC-3 (or
PCM) OPTICAL DIGITAL OUT
Connect the video signal and analog
audio signals to the VIDEO 2 jacks.
(See "Connecting video components")
Optical fiber cable
COAXIAL DIGITAL OUT
(AUDIO) | Component with an AC-3 (or
RCA pin cord LPCM) COAXIAL DIGITAL OUT
Connect the video signal and analog
audio signals to the VIDEO 3 jacks.
(See "Connecting video components'",)
F AC-3 RF OUT
{AUDIO}
RCA pin cord
To connect
an LD player with a DIGITAL
RF OUT.
Connect the LD player to the (optional) KENWOOD RF
digital demodulator (DEM-999D). Then connect the
demodulator to the VIDEO 4 DIGITAL IN.
EXTERNAL DC SUPPLY DC 12V
@ AC-3 RF INPUT
Connect this jack to the AC-3 RF OUTPUT jack on your LD player.
© POWER switch
Use to switch the power ON/OFF.
G DC IN (12V) jack
Connect this jack and inlet power cord to the AC adaptor supplied with
your demodulator.
Connect the power cord to a wail outlet after
completing all of the other connections.
Place the power
supply away from the demodulator,
receiver, and any antennas.
Advertisement
Table of Contents
