Pioneer PL-670 Operating Instructions Manual

Operating
Instructions
STEREO TURNTABLE
L-6
Thank you for buying this Pioneer product.
Please read through these operating instructions so you
will know how to operate your mode! properly. After you
have finished reading the instructions, put them away in
a safe place for future reference.
In some countries of regions, the shape of the power plug
and power outlet may sometimes differ from that shown
in the explanatory drawings. However, the method of
connecting and operating the unit is the same.
WARNING: to prevent Fine OR SHOCK HAZARD,
DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
IMPORTANT NOTICE
[For U.S. and Canadian models]
The serial number for this equipment is located on the rear
panel, Please write this serial number on your enclosed war-
ranty card and keep in a secure area. This is for your security.
"This product is manufactured to comply with the radio in-
terference requirements of EEC Directive 76/889/EEC and
82/499/ EEC."
LINE VOLTAGE SELECTOR SWITCH
Only multi-voltage models are provided with this
switch. U.S., Canadian, European, U.K., and Australian
models are not provided with this switch.
The line voltage selector switch is located on the top of the
cabinet of this turntable. Before your turntable is shipped from
the factory, the switch is set to the power requirements of the
turntabie's destination. Check that it is set properly before
plugging the power card into the outlet. If the voltage is not
Properly set or if you move to an area where the voltage re-
quirements differ, adjust the selector switch as follows:
@ Use a medium-sized screwdriver. tnsert the tip of the
screwdriver into the groove of the selector switch and
turn it so that the power voltage marking of your area
points to the arrow,
® PIONEER'