Tuning To A Station - Philips DC612 Operating Instructions Manual

TUNING TO A STATION
Briefly press the BND key to select the desired waveband:
FM1, FM2, FM3, MW1, MW2, LW, SW
[2] Tune to a radio station using:
Search tuning; Manual tuning; Recalling a preset station; or Auto-Store.
SEARCH TUNING (to quickly search for a station)
[1] Briefly press the ~« key {lower frequency} or i key (higher frequency).
[2] To search for another station, press the same key again.
m= LOCAL / DISTANT (influences search tuning on FM)
© Press the LOC key for at least 2 seconds {until you hear a beep] to switch between LOCAL and
DISTANT mode. {The display shows LOC' in the LOCAL mode}.
- In LOCAL mode the radio will first search for strong stations and then weaker stations.
— In DISTANT mode the radio will search for any receivable signal (useful in areas with weaker
FM signals).
MANUAL TUNING (if you know the frequency of the required station)
Press the MAN key for at least 2 seconds (until you hear a beep] to switch from search tuning
to manual tuning.
Note: The radio automatically switches back to search tuning (with a beep) after about | minute.
This radio has storage locations for:
(FM3 also used for Auto-store]
({MW22 also used for Auto-store}