Hitachi 53SDX89B Operating Manual page 28

HOW TO USE THE GENIUS REMOTE TO CONTROL YOUR TV
(_) EXIT button
When in MENU mode, this button will exit all On-Screen Displays.
(_) RECALL button
Press this button when no menu is displayed when you want to check the channel being received, the picture source, if the channel
has stereo (ST) or second audio program (SAP), the time, CHANNEL ID, if the Channel Skip (C.S.) function is activated, if SPECIAL
EVENT REMINDER is set, and if the SLEEP timer is set.
Audio Selected Maln Picture S_tce
Audio _. _
en_dcast ICHANNEL le
PiP lOfTA 12_
Sub-Pidum
Channel _,_S_lP (¢ S )
Skip m -- PIP
TIMERSLEEP-- _.EEp01S [_]" SPECIAL
EVENT
Illlllllllll REMINDER
When an S-Video
Input is connected
to Video: 1.
,,,t----- When a COMPONENT:
Y-CbCr Input is
connected to Video: 2.
If a HDTV quality signal
is input, it will display Y-
PBPR •
(_) MENU, CURSOR buttons
All the On-Screen Display features can be set or adjusted by using these buttons.
The MENU button will start the On-Screen Display.
The CURSOR buttons will highrightfunctions or adjust and set different features.
(_) CHANNEL SKIP button
Press this button when no menu is displayed and the "IV will tune to the last channel viewed. The user can change stations "SURF"
to any station they wish, and after 90 seconds, tune back to the original channel.
(_) SLEEP button
Press this button to display the sleep timer in the lower left corner of the screen. Every subsequent press of this button will add
15 minutes to this timer, up to a maximum of three hours. Once set, use RECALL when you want to view time remaining. If the
SLEEP button is pressed while the timer is set, it will reset to the original condition,
(_ INPUT button
The INPUT button will select between both antenna signals and the four sets of video inputjacks each time the button is pressed.
If the Picture-in-Picture is on, the INPUT button will select between the four sets of video input jacks and both antenna sources
when main channel is chosen with the PIP CH button. If the sub-picture is chosen, the INPUT button will select between the four
sets of video input jacks and the ANT A antenna source (ANT B source cannot be displayed as a PIP sub-picture and
COMPONENT: Y-CBCR/Y-PBP R Input 2 source will be displayed as a blank PIP Sub picture.)
INPUT
INPUT INPUT
INPUT INPUT
-!
INPUT
©
28