Husqvarna Blastrac EBE 350 Operator's Manual page 23

3. Remove the 3 screws, the 6 washers and the V-belt
cover.
4. Loosen the 4 bolts of the motor and remove the
strips if necessary.
5. Remove the small V-belt pulley and the V-belt.
6. Put the new V-belt on the large V-belt pulley.
7. Put the new V-belt around the small V-belt pulley.
8. Install the small V-belt pulley.
2111 - 001 - 21.07.2023
To replace the front rubber seals
1. Lift the front part of the product and tilt the product
rearward.
WARNING:
product does not tilt forward.
2. Loosen the 6 nuts and then loosen the 3 bolts.
Make sure that the
23