Media Usage/Compatibility; Media Characteristics By Media Library Parameters - Canon varioPRINT 6000 TITAN Series Manual

Canon

14. Media Usage/Compatibility

The varioPRINT 6000 TITAN Series engines maintain reliable, predictable, and
high-quality output. Consistency of the output is dependent on knowing and
compensating for the variables of a print job. The varioPRINT 6000 TITAN Series
engines incorporate many control systems which compensate for environmental
and print process conditions. Another variable is the print media. Knowing the
characteristics of the media facilitates optimal print output.

14.1 Media Characteristics by Media Library Parameters

This section describes the standard media library characteristics and parameters.
The following settings can be manually adjusted through the Settings Editor >
Media > Add icon. The Settings Editor can only be accessed via a Web browser
using the IP address of the varioPRINT 6000 TITAN Series. Media can also be
added at the UI on the operator panel.
The IP address of the varioPRINT 6000 TITAN Series is found on the machine's
operator panel through System > Local key operator settings > Connectivity >
TCP/IP address.
The table below describes the Add new media settings and each setting's
description.
Setting
Name
Size
Width (0.01 inches)
Length (0.01 inches)
Weight
Standard Type
Custom type name
Tab
Insert
Oriented
Cycle length
Punch holes
Standard color
Representation color
Coated
Revision 4 varioPRINT 6000 TITAN Series Customer Expectations Document
varioPRINT 6000 TITAN Series Customer Expectations Document
Set the name of the media.
Select the size of the paper from the drop-down list, including
custom size paper.
Specify the width of the custom paper in millimeters or inches.
Specify the length of the custom paper in millimeters or inches.
Specify the weight of the paper in g/m
Select the standard type from a pre-defined list/
Select the custom type name from a pre-defined list.
Select the check box to use tab paper, and then enter the cycle
length (how many tabs in one set).
Select the check box to use the paper as a sheet insertion, and
then enter the cycle length (how many sheet insertions in a set).
Specify letterhead or pre-punched paper.
Set the value 1 to N, where "N" is the number of sheets in one
cycle. Must specify the cycle length when specifying tab sheets
or sheet insertions.
Specify how many holes are in the pre-punched paper.
Specify the color of the paper. This setting acts as an identifier to
display the color of the paper on the operator panel.
Specify the RGB color value (0-255) for identification purposes
on the operator panel.
Specify the type of paper (e.g., Vellum, Coated, Textured).
Description
2 or lb.
Page 63