Advertisement
A
WARNING: When servicing, use only Identlcel
Craftsman replacement paKs. Use of any other part
may create a hazard or cause product damage.
_lb WARNING: Do not at anytime lat brake fluids,
gasoline, petroleum-basedproducts, penetrating oils,
etc. come in contact with plastic pans. They contain
chemicals that can damage, weaken or destroy
plastic.
Do not abase powertools. Abusive practicescan damage
tool as well as workplece.
A
WARNING: Do not attempt to modifythis worklight
or create accessories not recommendedfor use with
this worldlght.Any such alteration or modification Is
misuse and could result tn a hazardous condition
leading to possible seriouspersonalinjury.
FLUORESCENT
TUBE REPLACEMENT
See Figure 4.
When purchasingreplacement fluorescent tube, request
recommendedpart number 7819602. See Figure5.
TO REPLACE FLUORESCENT TUBE;
• Remove battery pack from workllght. See Page 8.
•
Remove screwto release lens cover. Remove lens
cover by pullingforward and lifting from the housing.
• To remove old fluorescent tube from spdng, gently
grasp the lower edge of the rubber cushionand sides
of bulb, Carefully work tube in a side-to-side motion
while easingtube forward and up untiltube Is free from
the spnng. Do not pull fluorescent tube straight out
from its center, as this Increases chance of breakage.
Remove rubbercushionfrom oldfluorescenttube and
place on top of new tube, rounded edge facing
outward,
•
Insert new fluorescenttube in spdng by aligning prongs
on tube with holes In tube socketarea, Gently push
down on base of new tuba untilfully engaged. Do not
force tube into place.
• Replace lens cover by slidinglower edge into housing.
Align screw holes at top, With a hand tool, tighten
screw. Do not use drtllincluded tn kitto tighten screw,
as drilltorque may damage lens cover.
•
Replace battery pack.
PULL LENS COVER
RUBBER
FORWARD TO REMOVE
CUSHION
SCREW
LENS COVER
FLUORESCENT TUBE
_J
BULB
SOCKET AREA
Fi_.5
Advertisement
