Siemens SINAMICS S120 Commissioning Manual page 4

Safety-related information
This Manual contains information which you should carefully observe to ensure your own personal safety
and to prevent material damage. Notices which are relevant to your own personal safety are highlighted by
a safety alert symbol; notices which are relevant only to equipment and property damage have no safety
alert symbol. They appear in decreasing order of risk as given below:
Danger
!
indicates that death or serious injury will result if proper precautions are not taken.
Warning
!
indicates that death or serious injury may result if proper precautions are not taken.
Caution
!
with a warning triangle indicates that minor personal injury can result if proper precautions are not taken.
Caution
without a warning triangle indicates that property damage may occur if proper precautions are not taken.
Notice
indicates that an unintended result or situation can occur if the corresponding information is not taken into
account.
If several hazards of different degrees occur, the hazard with the highest degree must always be given
priority. If a warning note with a warning triangle warns of personal injury, the same warning note can also
contain a warning of material damage.
Qualified personnel
The associated unit/system may only be set up and operated using this documentation. A device/system
must only be commissioned and operated by qualified personnel. Qualified persons are defined as per-
sons who are authorized to commission, ground, and tag equipment, systems, and circuits in accordance
with established safety standards.
Correct use
Please observe the following:
Warning
!
The unit may only be used for the applications specified in the catalog and in the technical description and
only in conjunction with the third–party equipment and components recommended by Siemens.
The successful and safe operation of the product depends on correct transport, proper storage and instal-
lation, as well as careful operation and maintenance.
Registered trademarks
All of the designations with the trademark R are registered trademarks of Siemens AG. Other names used
in this publication may be trademarks, which, if used by third parties for their own means, may violate the
rights of their owners.
Copyright Siemens AG 2006 All Rights Reserved
Reproduction, transmission or use of this document or its contents is not
permitted without express written authority. Offenders will be liable for
damages. All rights, including rights created by patent grant or registration
or a utility model or design, are reserved.
Siemens AG
Automation & Drives
Motion Control Systems
Postfach 3180, D-91050 Erlangen
Federal Republic of Germany
Siemens Aktiengesellschaft
Exclusion of liability
We have checked the contents of this manual for agreement with the
hardware and software described. However, deviations cannot be
completely excluded, so that we do not accept any guarantee for full
compliance. However, the data in this manual is reviewed regularly and
any necessary corrections included in subsequent editions.
E Siemens AG 2006
Subject to change without prior notice.
SINAMICS S120 Commissioning Manual, 03/2006 Edition