Adjusting The Throttle; Hydraulic System Maintenance; Hydraulic Fluid Specifications - Toro Reelmaster 3100-D Operator's Manual

Adjusting the Throttle

1. Prepare the machine for maintenance.
2. Unlatch and open the hood.
3. Position the throttle lever rearward so that it stops against the control panel slot.
4. Loosen the throttle cable connector
5. Hold the injection pump lever arm against the
low idle stop and tighten the cable connector.
6. Loosen the bolts securing the throttle control to
the control panel.
7. Push the throttle control lever all the way
forward.
8. Slide the stop plate until it contacts the throttle
lever and tighten the bolts securing the throttle
control to the control panel.
9. If the throttle does not stay in position during
operation, torque the locknut used to set the
friction device on the throttle lever to 5 to 6 N∙m (44 to 53 in-lb).
Note:
10. Close and latch the hood.

Hydraulic System Maintenance

Hydraulic Fluid Specifications

The reservoir is filled at the factory with high-quality hydraulic fluid. Check the level of the
hydraulic fluid before you first start the engine and daily thereafter.
Recommended hydraulic fluid: Toro PX Extended Life Hydraulic Fluid; available in 19 L (5
US gallon) pails or 208 L (55 US gallon) drums.
Note:
A machine using the recommended replacement fluid requires less frequent fluid and
filter changes.
Alternative hydraulic fluids: If Toro PX Extended Life Hydraulic Fluid is not available, you
may use another conventional, petroleum-based hydraulic fluid having specifications that
fall within the listed range for all the following material properties and that it meets industry
standards. Do not use synthetic fluid. Consult with your lubricant distributor to identify a
satisfactory product.
Note:
Toro does not assume responsibility for damage caused by improper substitutions, so
use products only from reputable manufacturers who will stand behind their
recommendation.
3466-297A
The maximum force required to operate the throttle lever should be 89 N (20 lb).
on the injection pump lever arm.
G416992
Page 6–29 Maintenance: Controls Maintenance