Kenwood 103AR Instruction Manual page 7

CqnnectiQn of antenna
AM loop antenna connection
The supolied antenna is for inaoo'' use. Place it as far as possible
from tne mam system, TV set, speaker cords and power cord, and
set i; to a direction which provides the best reception
AM outdoor antenna connection
If the reception is poor when the AM loop antenna is usea. distrib¬
ute a vinyl-coated wire of more than 6 meters outdoors, without
disconnecting the loop antenna
FM indoor antenna connection
Tne accessory antenna is for temDO^ary indoor use
oniy
For stable
Signal
receot'on we recommend us 'tg an outdoo' antenna Remove
tne nooo' antenna if you connect or^e outdoors
FM outdoor antenna connection
Lead the 75 Q coaxial cable connected to the FM outdoor antenna
into the room and connect it to the FM 75 U terminal
FM DE-EMPHASIS/CHANNEL SPACE switch
(Except for U.S.A., Canada and Australia)
The FM DE-EMPHASIS / CHANNEL SPACE switch on the rear oanel
IS set
'0
the correct setting that prevails m the area to which the
unit ts shipped However, if the FM DE-EMPHASIS CHANNEL
SPACE setting is not matched to the area where the un-t is to be
used, for instance, when you moved from area 1 to area 2 or vice
versa, desired reception of AM / FM broadcasts is not expected. In
this case, change the FM DE-EMPHASIS / CHANNEL SPACE set¬
ting in accordance wrtn the area corresponding to the tabre The EM
DE-EMPHASIS IS switched over at the same time
• When changing the setting of the FM DE-EMPHASiS / CHANNEL
SPACE switch, first disconnect the power cord of the amplifier,
then reset the channel space switch, connect the power cord
again, and turn the power on.
Area
CHANNEL
FM DE-
SPACE freq.
EMPHASIS
U S.A , Canada,
Hawaii, South
American countries
FM: 100kHz
AM: 10kHz
^5 ps
2
Other countries
FM: 50kHz
AM- 9kH7
50 MS