Time-Setting Options; Programming The Cooking Time; The Kitchen Timer - Bosch PIV8 F Series Instruction Manual

OTime-setting options
Y our hob has two timer functions:
T i m e - s e t t i n g o p t i o n s

Programming the cooking time

■
Kitchen timer
■
Programming the cooking time
The hotplate automatically switches off after the time
that is set has elapsed.
Setting procedure:
Select the hotplate and the required heat setting.
1.
Touch the 0 symbol.
2.
the hotplate. lights up on the timer display.
‹‹
Within the next 10 seconds, set the required cooking
3.
time in the settings range.
After a few seconds, the time begins to elapse.
The same cooking time can be set automatically
Note:
for all hotplates. The set time for each of the hotplates
counts down independently.
You can find information on automatically programming
the cooking time in section ~ "Basic settings"
Changing or cancelling the time
Select the hotplate and then press the
Change the cooking time using the programming zone
or set to in order to cancel the time.
‹‹
Once the time has elapsed
The hotplate switches off. A warning signal sounds. The
time program function lights up
the display.
When the symbol is pressed, the indications turn off
0
and the beeping stops.
Notes
To set a cooking time of under 10 minutes, always
■
touch 0 before you select the required value.
If a cooking time was programmed for several
■
hotplates, the time information for the selected
hotplate is shown in the timer display.
Select the relevant hotplate to call up the remaining
■
cooking time.
You can set a cooking time of up to
■
x lights up on the display for
0 symbol.
for 10 seconds in
‹‹
minutes.
ŠŠ

The kitchen timer

You can use the kitchen timer to set a time of up to 99
minutes.
This functions independently from the hotplates and
from other settings. This function does not automatically
switch off a hotplate.
Setting
Touch the symbol repeatedly until the
0
1.
indicator lights up. ‹‹
Set the desired time in the settings area.
2.
After a few seconds, the time begins to elapse.
Changing or deleting the time
Touch the symbol repeatedly until the
0
lights up.
Change the time in the settings area or set
to delete the programmed time.
When the time has elapsed
An audible signal sounds.
display and the V indicator lights up. The displays go
out after 10 seconds.
When the symbol is touched, the displays go out
0
and the audible signal ceases.

Time-setting options

V
lights up on the timer display.
indicator
V
in order
‹‹
appears on the timer
‹‹
en
13