Table of Contents
Advertisement
● To connect to the printer
1. Make sure that the imagePRESS Server and the printer are powered off.
2. Locate the printer interface cable.
3. Connect one end of the printer interface cable to the printer interface port on the back of the imagePRESS Server (see
"Connecting the imagePRESS Server" on page
4. Connect the other end of the printer interface cable to the printer.
5. Connect the crossover Ethernet cable to the lower RJ-45 port on the imagePRESS Server and the printer.
IMPORTANT:
The straight-through network cable at the customer site and the crossover Ethernet cable included with the
imagePRESS Server look similar, but are not interchangeable. Make sure that you connect the crossover Ethernet
cable to the Lower RJ-45 port on the back of the imagePRESS Server.
No.
1
Straight-through cable: wire arrangements are identical on both connectors
2
Crossover Ethernet cable: wire arrangements are different
NOTE:
Align Cables side by side and examine wires.
● To connect imagePRESS Serverto the network
1. Make sure that the is powered off.
2. Make sure that the network cable is connected to the customer site network.
3. Connect the network cable to the upper RJ-45 network port on the back of the imagePRESS Server (see
imagePRESS Server" on page
IMPORTANT:
The straight-through network cable at the customer site and the crossover Ethernet cable included with the imagePRESS
Server look similar, but are not interchangeable. Make sure that you connect the network cable to the upper RJ-45 port
on the imagePRESS Server connector panel. (see
The imagePRESS Server provides twisted pair connectivity to an Ethernet network. When the network cable is connected,
the Ethernet interface automatically detects the speed of the network environment. Depending on your network speed, the
following unshielded twisted pair (UTP) network cables are supported:
• 10BaseT: Category 3 or higher
• 100BaseTX: Category 5 or higher (4-pair/8-wire, short-length)
• 1000BaseT: Category 5e or higher (4-pair/8-wire, short-length)
13).
1
2 3
4
1
2 3
4
Figure 5: Straight-through and crossover Ethernet cables
13)
"imagePRESS Server hardware" on page
1
=
1
2 3
4
2
=
3
4 1
2
Item
16
2. INSTALLING HARDWARE
"Connecting the
29)
Advertisement
Table of Contents
