Craftsman 10 IN. TABLE SAW 315.22811 Owner's Manual page 45

[ Problem Cause Solution j
Positive stops inside cabinet need
adjusting (Bevel Cuts).
Saw does not make accurate 90 or
45 degree cuts.
Adjust positive stops.
Miter gage is misaligned
(Miter Cuts).
Adjust the miter gage.
Blade adjusting handle is hard to
turn.
Gears or Screw Post inside cabinet Clean the gears or screw post.
are clogged with sawdust.
Saw does not start. Motor cord or wall cord is not
plugged in.
Circuit fuse is blown.
Circuit breaker is tripped.
Cord or switch is damaged.
Plug in motor cord or wall cord.
Replace circuit fuse.
Reset circuit breaker.
Have the cord or switch replaced at
your Sears Service Center/Depart-
ment.
Blade makes poor cuts. Blade is dull or dirty.
Blade is wrong type for cut being
made.
Blade is mounted backwards.
Clean, sharpen or replace blade.
Replace with correct type.
Remount blade.
Blade does not lower when turning Back side of riving knife has come Realign and adjust the riving knife.
blade adjusting handle, in contact with saw table.
Locking lever is not at full left
position.
Move locking lever to left.
Motor labors in rip cut. Blade not proper for rip cut,
Change b!ade; rip blade typically
has fewer teeth.
45 rRRFTSMAN" TABLESAW315.228110