Entering Fireground Zone Channel (Conventional) - Motorola 3.5 User Manual

Entering Fireground Zone Channel
(Conventional)
1 Upon powering up, one of the following scenarios
occurs:
• If the Fireground Zone Channel is set as default,
you hear the gurgle tone and the radio displays
the home screen. You are in Fireground zone
channel.
• If the Fireground Zone Channel is set as default,
but you hear a short, low-pitched tone, the
display shows Reg failed to indicate that the
command terminal does not respond to
Fireground Zone Channel. Get a qualified
technician for assistance.
• If your home channel is not Fireground Zone
Channel, toggle or change the radio zone
channel to Fireground Zone Channel.
If you are entering Fireground Trunking Talkgroup,
upon powering up, ensure that the Fireground
Trunking Talkgroup is selected. The subscriber unit
automatically appears on the Incident Commander's
terminal.
2 Listen for a transmission. Adjust the Volume
Control Knob if necessary.
3 Perform one of the following actions:
• Press and hold the preprogrammed Volume Set
button to hear the volume set tone. Adjust the
Volume Control Knob if necessary. Release the
Volume Set button.
• At the desired Fireground zone and channel,
press the preprogrammed Monitor button and
listen for activity. Adjust the Volume Control
Knob if necessary.
• If your radio is working in Fireground Zone
Channel, proceed to next step.
4 Press and hold the PTT button to transmit. The LED
lights up solid red while transmitting. Talk into the
microphone clearly if needed.
5 Release the PTT button to receive.
You hear a Transmit End Tone.
English
107