Specifications; Attachments/Accessories; Operation; Before Using The Chain Saw - Toro Flex-Force Power System 51850 Operator's Manual

Specifications

Model
Bar Length (with 88613 and
88614 equipped)
Chain Gauge (with 88613
and 88614 equipped)
Chain Pitch (with 88613 and
88614 equipped)
Chain Length (with 88613
and 88614 equipped)
Rated Voltage
Weight (without a battery)
Charger Type
Battery Type
Appropriate Temperature Ranges
Charge/store the battery pack
at
Use the battery pack at
Use the tool at
*Charging time will increase if you do not charge the
battery within this range.
Store the tool, battery pack, and battery charger in an
enclosed clean, dry area.

Attachments/Accessories

A selection of Toro approved attachments and
accessories is available for use with the machine
to enhance and expand its capabilities. Contact
your Authorized Service Dealer or authorized Toro
distributor or go to www.Toro.com for a list of all
approved attachments and accessories.
To ensure optimum performance and continued safety
certification of the machine, use only genuine Toro
replacement parts and accessories. Replacement
parts and accessories made by other manufacturers
could be dangerous.
51850/51850T
40.6 cm (16 inches)
0.043 inches
3/8 inch
56 links
60V DC maximum, 54 VDC
nominal usage
4.35 kg (9.59 lb)
Toro 60V lithium-ion chargers
Toro 60V lithum-ion batteries
5°C (41°F) to 40°C (104°F)*
-30°C (-22°F) to 49°C (120°F)*
0°C (32°F) to 49°C (120°F)*

Operation

Before Using the Chain Saw

Before using the chain saw, do the following:
•
Check the chain tension; refer to
Chain Tension (page
•
Clean the chain saw components, inspect them for
excessive wear or damage, and replace them as
needed; refer to
and Drive Sprocket (page
•
Check the chain for sharpness and damage, and
sharpen or replace as needed; refer to
the Chain (page
•
Check the oil level; refer to
and Adding Bar and Chain Oil (page
•
Check the chain brake; refer to
Chain Brake (page
•
Check the chain saw for damage, general
appearance, and performance; ensure that the
switches move freely, the vents and handles are
clean, and the bar is not bent or damaged.
11
Adjusting the
22).
Servicing the Guide Bar, Chain,
23).
Sharpening
24).
Checking the Oil Level
20).
Checking the
21).