Toro 500 EFI Service Manual page 160

REMOVING FRONT DRIVE AXLE

NOTE: For removing a front drive axel, see Front
Differential in this section.
CLEANING AND INSPECTING AXLES

NOTE: Always clean and inspect the drive axle com-
ponents to determine if any service or replacement is
necessary.
1. Using a clean towel, wipe away any oil or grease
from the axle components.
2. Inspect boots for any tears, cracks, or deterioration.

NOTE: If a boot is damaged in any way, it must be
replaced with a boot kit.
DISASSEMBLING AXLES

NOTE: Only the boots are serviceable on the axles;
if any other component is worn or damaged, the axle
must be replaced.
1. Using CV Boot Clamp Tool, remove and retain both
clamps for assembly purposes.
158
PR729C
2. Place the white-striped end of the CV joint into a
vise.
3. To disengage the axle from the CV joint, sharply pull
back on the axle; then slide the boot off of the axle.
CD019

NOTE: Steps 1-3 can be used to replace the out-
board boot.
ASSEMBLING AXLES
1. Install the inner boot with the small clamp making
sure the ends of the clamp are positioned correctly.

NOTE: The boot is positioned correctly when the
small end of the boot seats down into the recessed
groove.
2. Using the boot clamp tool, secure the small clamp of
the inner boot.
CF337
CF335
CF334