Canon imagePASS-P2 Service Manual page 60

3. Power on the Windows computer and do the following:
NOTE:
• Start the Fiery Installer Builder.
Double-click the Fiery Installer Builder icon on the desktop or you can also click Start > EFI > Fiery Installer Builder.
• Close all the software applications except the Fiery Installer Builder.
• Make sure that the Windows computer is configured to obtain its IP address automatically (DHCP).
• Remove any network cables between the Windows computer and the customer network.
• Disable all power-save and hibernation settings.
IMPORTANT:
It is important that you complete all of the tasks in the preceding list. If you do not complete these tasks, the installation
may fail.
4. At the Downloaded window of the Fiery Installer Builder, select Canon imagePASS-N2/P2 1.0.
5. From the Preparation action list, select Perform Network installation.
4. INSTALLING SYSTEM SOFTWARE
55