Table of Contents
Advertisement
Feeding the Material
a
While keeping the left edge of the leader sheet along the
rolled material guide (1), lightly insert it under feed
rollers (2).
2
1
a Rolled material guide
b Feed roller
Note
• Before pressing the "Feed" button, check that the guide
channel and the alignment position mark of the leader
sheet are aligned.
1
2
a Guide channel
b Leader sheet alignment position line
b
With the leader sheet caught by the rollers, support it
with your hand so that it does not shift position, and press
leader sheet forward.
2
1
on the operation panel while gently pushing the
When the material is fed into position, preparation of the roll
feeder is completed. At this time, make sure that the left and
right feed rollers completely pass over the leader sheet.
Memo
• If the material becomes jammed, remove any jammed
material. For details, see "When Material Has Become
Jammed in the Machine" on page 31.
15
Advertisement
Table of Contents
