2.5.2
Installing an ASUS PIKE II card
You may install an ASUS PIKE II card to the internal SAS/HBA/Storage bracket located in
the front of the system (ESC4000 G4 and ESC4000 G4S only) or the riser bracket located in
the rear of the system. An additional Cache Vault Flash Module can also be installed in the
ESC4000 G4S server system.
To install an ASUS PIKE II card to the front of the system:
ESC4000 G4
1.
Remove the default cable from the motherboard and the backplane.
2.
Remove the screw from the bracket (A), then push the internal SAS/HBA/Storage
bracket towards the rear to remove the internal SAS/HBA/Storage bracket (B).
2-22
Chapter 2: Hardware Setup