Hdmi (Arc) Audio Source; Play Audio Through Bluetooth; Auto Standby; Apply Factory Settings - Philips 5000 Series User Manual

The soundbar's indicator turns solid
yellow.
Note: The TV audio output must be set to
PCM signal.

HDMI (ARC) audio source

ARC (Audio Return Channel) is used in digital
audio output of liquid crystal display television
in order toget the optimal synchronous sound
quality.
1
Connect the TV to your soundbar via the
HDMI cable (not included). Refer to Page 8
for steps of HDMI (ARC) connection.
2
Press HDMI (ARC) on the remote
The soundbar's indicator turns solid
purple.
Note: The TV audio output must be set
to PCM signal and ARC on (refer to the
manual of the TV).

Play audio through Bluetooth

Through Bluetooth, connect the soundbar with
your Bluetooth device (such as an iPad, iPhone,
iPod touch, Android phone, or laptop), and then
you can listen to the audio files stored on the
device through your soundbar.
What you need
• A Bluetooth device which supports
Bluetooth profile A2DP and AVRCP, and
with Bluetooth version 4.2 or above.
• The operational range between the
soundbar and a Bluetooth device is
approximately 4 meters (13 feet).
1
Press BT/Pair on the remote control to
switch the soundbar to Bluetooth mode.
The soundbar's indicator blinks blue.
2
On the Bluetooth device, switch on
Bluetooth, search for and select Philips
TAB5308 to start connection (see the user
manual of the Bluetooth device on how to
enable Bluetooth).
During connection, the soundbar's
indicator blinks blue.
3
Wait until the soundbar's indicator turns
solid blue, and a beep sound will be heard
upon a successful connection.
EN
10
4
5
control.
• The music streaming may be interrupted by
obstacles between the device and soundbar;
such as wall, metallic casing that covers the
device, or other devices nearby that operate in
the same frequency.

Auto standby

This product automatically switches to standby
after 15 minutes of button inactivity and no
audio play from a connected device.

Apply factory settings

You can reset your soundbar to the default
setting mode.
•
If the connection fails, the indicator blinks
continually.
Select and play audio files or music on your
Bluetooth device.
• During play, if a call comes in, music
play is paused.
• If your Bluetooth device supports
AVRCP profile, on the remote control
you can press
or press to pause/resume play.
To exit Bluetooth, switch your soundbar to
another source.
• When your switch back to Bluetooth
mode, Bluetooth connection remains
active.
Disconnect from the current device:
• If you want to connect your soundbar
with another Bluetooth device, press
and hold BT/PAIR on the remote
control to disconnect the currently
conected Bluetooth device.
Indicator status
Waiting to connect: Blinking blue
Connected: Solid blue
Disconnected: Blinking blue
Note
In AUX mode, press and hold
remote control for 5 seconds.
The factory settings is restored.
to skip to a track,
on the