Silvercrest KH 2302 Operating Instructions Manual page 23

• Arrange for defective power plugs and/or cables
to be replaced at once by qualified technicians
or our Customer Service Department.
• Get customer service to repair or replace con-
necting cables and/or devices that are not
functioning properly or have been damaged.
• Only use the device in dry rooms.
NEVER submerse the device in water.
Wipe it only with a slightly damp cloth.
• Make sure that liquids or objects are never able
to enter into the device.
• Do not place water-filled receptacles (e.g. flower
vases) on the device.
• Position the device close to an electrical wallsocket.
Make sure that the wall socket is easily accessible
• To avoid the risks of tripping, do not use an ex-
tension cable. In the event of danger, the plug
must be quickly and easily accessible.
• Do not open the housing or attempt to repair the
device yourself. Should you do so, device safety
can no longer be assured and the warranty will
become void.
Repairs are to be carried out exclusively by a
specialist firm or the service centre.
Notice regarding separation from
mains-power
POWER
The switch does not completely disconnect
the device from the power network. Additionally,
the device consumes power when in standby-
mode. To completely separate the device from
mains-power, the power plug MUST be removed
from the wall socket.
Information regarding the handling
of batteries
The remote control requires batteries. For the handling
of batteries please observe the following:
Risk of explosion!
Do not throw batteries into a fire. Do not
recharge batteries.
• NEVER open batteries, NEVER solder or weld
batteries.
The risk of explosions and injuries exists!
• Regularly check the condition of the batteries.
Leaking batteries can cause damage to the
device.
• If you do not intend to use the device for an
extended period, remove the batteries.
• In the event of the batteries leaking acids, wear
protective gloves.
• Clean the battery compartment and the battery
contacts with a dry cloth.
To avoid the risks of fire or injury:
• Do not place candles or other open fire sources
on the device.
• Do not use the device near hot surfaces.
• Do not place the device in locations exposed to
direct sunlight. If you do, it may overheat and be-
come irreparably damaged.
• To prevent heat build up, place the device at
a location with adequate ventilation .
• Never cover the ventilation openings!
• Avoid any additional heat build up, e.g. direct
sunlight, heaters, other devices, etc.
• Keep children away from the connecting cable
and the device. Children frequently underestimate
the danger from electrical devices.
• Provide for a safe location for the device.
• Do not operate the device if it has sustained a
fall or is damaged. Arrange for the device to be
checked and/or repaired by qualified technicians.
- 21 -