Husqvarna HG 125 VS Original Instructions Manual page 15

Concrete Dust Extraction
Attachment for Surfacing
Grinding Assembly
for all tool operations. Do not discard
guard when not in use. Always reinstall
wheel guard when converting back to
grinding operations.
guard, do not use with bonded abrasive
wheels. Dust extraction attachment may
not protect operator in the event of a wheel
burst.
To install concrete dust extraction
attachment (Fig. 9):
1.Unplug tool from power source.
2.Position appropriate attachment on
spindle neck with dust port pointing away
from tool body.
3.Rotate attachment clockwise 90º until
guard clicks in place.
4.Adjust attachment by depressing guard
release lever and rotate to desired
position.
5.Allow guard release lever to click in place.
6.Place the backing flange on the spindle.
7.Place the diamond cup wheel onto the
spindle and align with the flange.
8.Thread the lock nut onto the spindle with
the lock nut relief facing the accessory.
9.Tighten lock nut with supplied lock nut
wrench while holding spindle lock.
When using spin on wheels, follow steps 1 -
5, then thread wheel directly onto spindle
without using the supplied flanges.
TO REMOVE: Reverse procedure.
Assembly Instructions
A type 27 grinding wheel
guard may not be used
Dust Extraction
Attachment is not a
FIG. 9
SPINDLE
CONCRETE DUST EXTRACTION
A
-15-
ATTACHMENT
B