Table of Contents
Advertisement
Follow these steps to use the MB91360 Flash Programmer :
1. Connect a serial cable (RS232 „extension"-type 1:1 / male-female)
from a PC COM-port (1-4) to your CPU-board „UART0"-connector.
2. Specify a (hex-)file in the "file to program"-field (use the browse-button
to select). This file must be a converted linker output file from Softune
in the Motorola™ Hex-Format "*.MHX" (for programming your own
applications, be sure to have the load module converter started in
Softune Workbench to generate MHX-files !).
3. Specify the COM-port, CPU-type (depending on your CPU-board)
and the desired baudrate for programming.
4. Press and hold on the reset button on the CPU-module, then click
Automatic Mode and release the reset button. The programming
sequence will be executed automatically (You may also use the
connect button in the same way first to assure a working connection
before using the „Automatic mode").
CAUTION : DO NOT INTERRUPT THE FLASH PROGRAMMING OR
CUT
OFF
IT CAN DAMAGE THE FLASH ROM PERMANTENTLY !!!
5. After a successful programming procedure, hit reset of both boards to
invoke the application you have programmed.
i
Take special care not to write anything to the „security vector". If you
do, you will not be able to re-program the device ever again ! This
vector is left blank on all provided templates. See the hardware
manual for details !
i
The Flash Programmer uses the internal Boot-ROM functions of the
MB91F36x device for flash programming. See the hardware manual
for details !
For more information and trouble shooting, see the „MB91360 Serial
flash programmer user's guide" (Flashprg.pdf) which is included in
the installation.
THE
POWER
page -11-
DURING
PROGRAMMING
!
Advertisement
Table of Contents
