Changing The Screen Mode - Sony LF-B1 Settings Manual

1 Used to switch the function to be
controlled by the remote control for
multifunction devices such as hard disk/
DVD combined video recorders.
2 Used to turn the connected device on/off
3 Used to switch among control panels for
connected devices with remote controls
that have multiple control panels
4 Used to operate the connected device
Notes
• Save remote control data in the following location
on your Memory Stick Duo™:
• Use the same method of operation as you would with
the remote control supplied with the connected
device. However, buttons for features that are not
available in the connected device cannot be used even
if they are shown on the on-screen remote control.
• Button names as shown on the on-screen remote
control may be different from the names shown on the
remote control supplied with the connected device.
• When using a multifunctional connected device such
as a combined Hard Disk/- or DVD player/video
deck, if the function controlled by the remote control
(see figure 1 on the previous page) is not set
correctly the remote control will not function after the
connected device is turned on. In this case, switch the
function controlled by the remote control to the
function in use.

Changing the Screen Mode

1
Select from the control panel, and
then press the
Each time the button is pressed, the
Screen Mode will change as follows:
button.
Type
Zoom The image is shown at full screen
size without changing proportions,
while cutting off the top and bottom
or left and right areas.
Full Screen The image is shown in the full screen
size by changing proportions and
zooming in horizontally and
vertically.
Original The image is shown in the original
size.
Normal The image is adjusted to fit the
PSP™ system's screen size.
Adjusting the Video Rate
Adjusts so that you see an optimized image
depending on network conditions.
Normally, selecting [Automatic] sets the optimal
video rate in accordance with available
bandwidth.
When selecting a rate manually, a higher rate (a
larger number) results in better picture quality but
also requires larger bandwidth. Note that
insufficient bandwidth may cause the video to
stop intermittently.
1
Select from the control panel, and
then press the
The screen for selecting a rate is displayed.
2
Using the directional buttons, select
the desired rate, and then press the
button.
The rate is changed.
11
Description
button.