Table of contents Ú Ú I n s t r u c t i o n s f o r c o n n e c t i n g g a s a n d g a s c o n v e r s i o n ( f o r A f t e r - S a l e s S e r v i c e o n l y ) Important information..............
Important information The appliance must only be converted from one gas type to Risk of gas escape! another by authorised personnel who have received After connecting the appliance to the gas supply, always ■ appropriate training. The procedure must always be carried check the connection for leak tightness.
Gas connection Approved connections Natural gas connection (NG) If natural has (NG) is used, the gas supply should be These instructions apply only when the appliance is set up in connected via a gas pipe or a safety gas hose with threaded countries that are indicated on the rating plate.
Secure the connection piece using a 24 mm spanner. Use a Connection in accordance with EN 10226 R (TS 61-210 EN 24 mm spanner to place the threaded fitting of the gas pipe 10226 R or safety gas hose on the connection piece and tighten it Place the new seal in the connection piece.
Conversion to a different gas type Changing the gas type (*) Connecting piece for liquid gas (LPG: G30, G31) Change the gas connection piece. ■ Change the burner nozzles. ■ The bypass nozzles of the burner taps will need to be ■...
Setting the burner bypass nozzles and a small Remove the pan supports and the burner parts. flame The bypass nozzles are used to set the minimum flame height for the burners. Preparation Close the gas connection shut-off. Risk of electric shock! Disconnect the appliance from the mains.
Take the knobs off the hob top by pulling them towards you. If an upper appliance cover is available, hold this on both Remove the screws in the corners of the front panel. sides and lower it vertically into the holder (optional). Refit the pan supports.
Remove the nozzle for the grill burner using a 7 mm box Replacing the nozzle for the grill burner (optional) spanner. Open the oven door. Remove the two fastening screws on the grill burner nozzle holder. Select the appropriate nozzle from the table depending on the new gas type.
Checking the oven burner nozzle (option) Check the grill burner nozzle (option) Open the gas supply. Open the gas supply. Carefully close the hole in the oven burner nozzle using your Carefully close the hole in the grill burner nozzle using your finger or a suitable device.
Technical data – Gas Different types of gas and the corresponding values are listed here. Gas type mbar Nozzle Burner type Power Power Max. consumption (kW) min. (kW) (mm) Bypass G20 (l/h) G30 (g/h) Natural gas 1,16 0,78 High output burner ≤...