Table of Contents
Advertisement
Faults and what to do about them
en
Fault
Grey residues on the
washing.
Programme termi-
nated unexpectedly.
Drying result notsatis-
factory.
Spinning during dry-
ing.
The fabric softener is
not completely flushed
in or too much water
remains in the com-
partment.
The laundry is not
dried.
No display on the dis-
play panel.
The door cannot be
opened.
48
Possible cause
Soiling caused by ointments, grease
oroil.
Press the Start/Pause I button
elected accidentally.
The laundry clings to the sides of the-
drum after being spun
Closed tap
Selected drying time too short
Maximum or minimum load not taken
into account
No fault
The fabric softener compartment insert
is not correctly attached or is blocked.
The tap is turned off.
The load is too large.
The drying time is too short.
Power cut
Rinse hold has been selected
The programme is running or the dooris
locked for safety reasons
Power cut.
Remedial Action
Wash the laundry using the maximum-
detergent dosage and the maximump-
ermissible temperature – see thecare
label.
Turn on the tap.
Loosen up the laundry by hand; start
the drying programme.
Turn on the tap
Select the drying time according to the
Load.
Once the programme has ended: adjust
the load quantity, select a suitable dry-
ing programme and restart.
"Thermo spin", which is for energy-effi-
cient drying, starts after a drying time of
approx. 10 minutes.
If necessary, clean the fabric softener
compartment insert and fit it correctly in
compartment.
Turn on the tap.
Reduce the load size.
Select a suitable drying time.
The programme continues when pow-
eris restored. If you wish to remove the-
laundry during a power cut, you must
first Drain out the water. Check
whether:– the plug is plugged into the
socketcorrectly.– the circuit breaker
(fuse) hastripped; if it has, call the after-
salesservice
Select the programme p+0Empty
+Spin
and press the Start/Pause I button.
Wait until End appears on the display
panel.
Unlock the door mechanically
Advertisement
Table of Contents
