NIC2-2 · Network ID Camera
1.4 Service tools
Use the following tools to repair a Network ID camera:
• Philip Screw Driver size PH2
• TORX Screw Driver size 10
• TORX Screw Driver size 20
• Socket head cap screwdriver 2.0 mm
• Box socket wrench 8.0 mm
• Digital Multimeter:Voltage 5 to 24V
• Resistance 0 to 100 ohm
• GluePrimer, Loctite 770 Polyolefin
• Glue, Loctite 406 Cyanoacrylate
• Nut retentionLoctite 243
To update the firmware or upload or download set-up, computer equipment is needed:
Service Computer: 100% IBM compatible
Service Software:
Triacon AB Sweden
Hard disk
VGA Monitor display
1 RS 232 Serial Interface
CD Drive or Internet connection
1 9pin male-female Serial Interface Cable
NIC Setup Manager. This programme is needed to upgrade the firm-
ware and to upload and download the set-up. The software can be
downloaded from Triacon's homepage. It is also distributen on a CD
ROM disk for a minor administration cost.
3
Publication no. 201102
September 2003