Basic Operations - Kenwood NEXEDGE NX-720 Series Instruction Manual

1 Available only for Analog Trunking operation.
2 Available only for NXDN Trunking operation.
3 Available only for NXDN Conventional operation.
4 Emergency can be programmed only on the
set the key assignment hold to "Enable" and second function as "Emergency".
5 Available only for NXDN Conventional operation and NXDN Trunking operation.
6 Available only for Analog Conventional, Analog Trunking, and NXDN Conventional
operation.
7 Available only for Analog Conventional operation.
8 Available only for Analog Conventional and NXDN Conventional operation.
Available only for Analog Conventional and Analog Trunking operation.
9
SWITCHING POWER ON/ OFF
Press to switch the transceiver ON.
• A beep sounds and the display illuminates.
• If the Transceiver Password function is programmed, "PASSWORD" will appear on the
display.
Press again to switch the transceiver OFF.
■ Transceiver Password
To enter the password:
1 Press the / key to select a digit.
• When using a keypad, simply enter the password digits and proceed to step 4.
2 Press the S or
• Press the A or # key to delete an incorrect digit.
• Press the C> key to delete all.
3 Repeat steps 1 and 2 to enter the entire password.
• The password can contain a maximum of 6 digits.
4 Press the S or
• If you enter an incorrect password, an error tone sounds and the transceiver
remains locked.
ADJUSTING THE VOLUME
Press the [Volume Up] key to increase the volume. Press the [Volume Down] key to
decrease the volume.
If Squelch Off has been programmed onto a key, you can use that function to listen to
background noise while adjusting the volume level.
6

BASIC OPERATIONS

key to accept the entry and move to the next digit.
key to confirm the entered password.
key. When assigned, the dealer must