Specifications - Toshiba 288V Installation And Operation Manual

Charging the Batteries after a Complete Discharge
1. When the UPS has fully discharge the batteries and hits the shutdown voltage, the UPS will shutdown and lose out-
put. This will cause the SCiB ESS to lose control power which will trigger the UVR in the SCiB ESS MCCB1 causing
it to trip.
2. Once power is restored and the UPS is back in the "ONLINE" mode, ensure that the control power breaker in the MBS
(CB6) is still closed.
3. Ensure the control power breaker (CB1) is closed in the SCiB ESS. This breaker should still be in the "ON" position
since the UVR only effects MCCB1.
4. Ensure the red LED is flashing 2 times and then off for 8 seconds. The green and amber LEDs will be off.
5. Turn on MCCB1.
6. The green and amber LEDs will flash indicating the contactor is open and then will turn off once the contactors close.
The alarm on the UPS "ESS Alarm" should clear.
7. The green LED will start flashing indicating the batteries are being charged. When the green LED is solid, this indi-
cates the batteries are fully charged.
9

Specifications

28
288V SCIB ENERGY STORAGE SYSTEM
Capacity
Nominal Voltage
Voltage Range
Maximum Charge Voltage
Maximum System Charge Current
Max Discharge Current
DC Breaker Rating
Breaker Control
Parallel Capability
Module Type
Modules Per String
Operating Temperature
Ambient Humidity
Enclosure
Storage Temperature
Storage Humidity
Unit Weight
Shipping Weight
Unit Dimensions
Shipping Dimensions
Cable Entry
AC Input (Control Power)
288V SCiB Energy Storage System Installation and Operation Manual – 203810-000
11kWh, 45Ah
248VDC
215-285VDC
285VDC
10ADC
125A
125AT, 500VDC, 20kAIC
Shunt Trip
2-8 Cabinets
Type 3-23 2P12S Module
9
0 to 40°C
5-80% non-condensing
NEMA 1, Indoor Only
-10 to 55°C
5-85% non-condensing
600lbs (272kg)
665lbs.(302kg)
11.9" W x 37.1" D x 66.8" H
31" W x 46" D x 76" H
Top, Bottom
208VAC, 5A, 2 wire