Table of Contents
Advertisement
Driving Forward up a Curb
1. Disengage the mower blades.
2. Select the first gear to drive the machine.
3. Drive machine until the caster wheels contact the curb
(Figure
11).
4. Lift the front of the machine by pushing down on the
lower handle
(Figure
5. Drive the machine until the drive wheels contact the
curb
(Figure
11).
6. Lower the front of the machine
Note: Both drive wheels should contact the curb and
caster wheels straight.
7. At the same time engage the lower control bar and lift
up on the lower handle to drive over the curb
10
and
Figure
11).
Note: Lifting up on the lower handle will assist driving
the machine up a curb and not spin the drive wheels.
1. Lower control bar engaged
and mower in reverse
2. Pull up to assist machine
Driving Backward up a Curb
1. Disengage the mower blades.
2. Select reverse to drive the machine.
3. Drive the machine until drive wheels contact curb
(Figure
11).
Note: Both drive wheels should contact the curb and
caster wheels straight.
4. At the same time engage lower control bar and lift up
on the lower handle
11).
(Figure
11).
Figure 11
3. Lower control bar engaged
and mower going forward
(Figure 10
and
Figure
12).
Note: Lifting up on the lower handle will assist driving
the machine up a curb and not spin the drive wheels.
(Figure
1. Lower control bar
(engaged)
Stopping the Machine
To stop the machine, pull back on the upper control bar,
release the blade-control bail, turn the ignition key to the off
position, and set the parking brake; refer to
Parking Brake (page
the ignition switch.
CAUTION
Children or bystanders may be injured if they
move or attempt to operate the machine while it is
unattended.
Always remove the ignition key and set the parking
brake when leaving the machine unattended, even
if just for a few minutes.
Transporting the Machine
Use a heavy-duty trailer or truck to transport the machine.
Ensure that the trailer or truck has all necessary lighting and
marking as required by law. Please carefully read all the safety
instructions. Knowing this information could help you, your
family, pets or bystanders avoid injury.
To transport the machine:
1. Stop the engine, remove the key, set the brake, and
close the fuel valve.
2. Securely fasten the machine to the trailer or truck with
straps, chains, cable, or ropes.
3. If using a trailer, secure the trailer to the towing vehicle
and install the safety chains.
18
Figure 12
2. Handle
Operating the
15). Remember to remove the key from
Advertisement
Table of Contents
