Advertisement
en Installation instructions
5.
Use the two screws to tighten the two metal retain-
ers on the back of the appliance.
Ensure that the metal retainers are aligned ex-
‒
actly with the edge of the appliance.
6.
Slide the appliance into the fitted unit and check
whether the tilt protection engages.
7.
If required, correct the position of the bracket with
the elongated hole.
8.
Finally, screw the brackets to the fitted unit.
9.
Push the appliance into the fitted unit.
6
10.
Remove the adhesive strip from the appliance front.
11.
Open the appliance carefully and check whether the
tilt protection is working.
Installing the appliance
1.
Push the appliance all the way into the fitted unit.
2.
Centre the appliance.
3.
Remove the adhesive strip from the appliance front.
4.
Open the appliance.
5.
Screw the appliance to the fitted unit.
Adjusting the appliance front
Adjust the appliance front upwards or downwards if ne-
cessary.
1.
Open the appliance.
2.
Undo the screws on the side of the panel.
3.
Align the appliance front upwards or downwards.
Alignments of maximum -3 to +3 mm are possible.
4.
Tighten the screws.
Combining the accessory drawer with another
appliance
ATTENTION!
Sharp edges on the appliance may damage the panel
of the accessory drawer.
▶
Do not damage the accessory drawer cover when
sliding the appliance in.
1.
Only combine suitable appliances of the same
brand and series.
2.
First fit the accessory drawer.
3.
Slide the appliance onto the accessory drawer into
the built-in cabinet.
4.
Observe the installation instructions for the appli-
ance.
Advertisement
