Table of Contents
Advertisement
CAUTION
!
• Power Cable Specification : The power cord connected to the outdoor unit should be
complied with IEC 60245 or HD 22.4 S4(Rubber insulated cord, type 60245 IEC 66 or
H07RN-F)
10±3 mm
1 Phase(Ø)
• Connecting Cable Specification : The connecting cable connected to the outdoor unit
should be complied with IEC 60245 or HD 22.4 S4 (This equipment shall be provided with a
cord set complying with the national regulation.)
4C
Capacity (kW)
Connecting
Cable
• If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons
in order to avoid a hazard.
• In order to avoid a hazard due to inadvertent resetting of the
thermal cut-out, this appliance must not be supplied through
an external switching device, such as a timer, or connected
to a circuit that is regularly switched on and off by the utility.
WARNING
!
Followings should be kept before wiring.
• Supply type of electric heater should be ensured.
• Never connect electric power while wiring electric heater.
• The wire that is connected to electric heater should be used to meet specification of each
country.
• Main power of electric heater should be applied with ELCB.
10±3 mm
3 Phase(Ø)
NORMAL
CROSS-SECTIONAL
2
AREA 0.75 mm
Purpose
SIGNAL (Electric Heater)
3
Sensor
SIGNAL (Electric Heater)
6
Sensor
SIGNAL (Electric Heater)
6
Sensor
INSTALLATION METHOD
Capacity
Phase
(kW)
Power
3
Supply
6
6
2C
NORMAL
CROSS-SECTIONAL
AREA 0.75 mm
Phase (Ø)
Area (mm
1
3
15
Area (mm
2
) x
(Ø)
Cores
1.5 x 3C
1
4 x 3C
3
2.5 x 4C
2
2
) x Cores
0.75 x 2C
0.75 x 2C
0.75 x 4C
0.75 x 2C
0.75 x 2C
0.75 x 2C
Advertisement
Table of Contents
