Fujitsu Halcyon AGU9RLF Operating Manual page 5

Fig. 1 Indoor Unit
1 Operating Control Panel (Fig. 2)
2 Air Outlet Selection switch
3 MANUAL AUTO button
●
When the MANUAL AUTO button is pressed
in for more than 10 seconds, the forced
cooling operation will start.
●
The forced cooling operation is used at the
time of installation.
Only for authorized service personnel's use.
●
When the forced cooling operation starts by
any chance, press the START/STOP button
to stop the operation.
4 Indicator (Fig. 3)
5 Remote Control Signal Receiver
6 OPERATION Indicator Lamp (green)
7 TIMER Indicator Lamp (orange)
●
If the TIMER indicator lamp flashes when
the timer is operating, it indicates that a fault
has occurred with the timer setting (See
Page 16 Auto Restart).
8 ECONOMY Indicator Lamp (green)
9 Intake Grille (Fig. 4)
0 Front Panel
A Air Filter
B Air ow Direction Louver
C Damper
D Right-Left Louver
(behind Airflow Direction Louver and
Damper)
E Drain Hose
F Air Cleaning Filter
G Rope
9378532076_OM.indb 5
Fig. 5 Remote Controller
1 START/STOP button
2 MODE button
3 SET TEMP. (temperature) buttons
4 Remote controller display
5 POWERFUL button
6 MIN. HEAT button
7 Signal transmitter
8 FAN button
9 SWING button
0 SET button
A SLEEP timer button
B CANCEL button
C RESET button
●
When you press the RESET button, press
it gently by using the tip of a ballpoint pen
or other small object in correct direction as
shown in this gure.
RESET
D CLOCK ADJUST button
E OFF timer button
F ON timer button
G SELECT button
H ECONOMY button
I °C / °F button
J SWING display
En-5
9/24/2013 4:35:26 PM