Philips EasyKey 1000 Series User Manual page 12

LED flashes blue twice and
short "beep" sound
LED flashes green twice and
two "beep" sounds
Attention
1. Unable to enter the setup mode using
user fingerprint.
2. Enrolled fingerprints cannot be
registered for a second time.
3. In setup mode, if there is no operation for
more than 10 seconds, the buzzer emits a
single "beep" sound, the red light stays on
for 2 seconds, and the system automatically
exits the setup mode.
User fingerprint
User fingerprints can be used for daily
unlocking and remain valid permanently
unless the system is restored to default
settings.
10
During the first 7 presses
emits a
On the 8th press
emits
Add a user fingerprint
User fingerprints can be used for daily
unlocking and remain valid permanently
unless the system is restored to default
settings.
Prerequisite: Before adding user
fingerprints, you need to successfully
enroll a master fingerprint.
Press the setup button, the buzzer
1
will emit a "beep" sound, and the
blue light will stay on continuously,
indicating that the device has entered
the setup mode.
AAA
AAA
Click
LED in blue and
sound
After enrolling a successful master
2
fingerprint, use the enrolled master
fingerprint for verification. When
the master fingerprint is successfully
verified, the buzzer will emit a "beep"
sound, and the blue light will stay on.
If the master fingerprint verification
fails, the indicator will flash red twice,
and the buzzer will emit three "beep"
sound.
AAA
AAA
emits a long "beep"