Multiview Faqs - Philips 34B1U5600CH User Manual

3. Scroll down and select 'WbioSrvc'
(Windows Biometric Service). If
the status shows 'Running', right
click to stop the service first, then
restart the service manually.
4. Then go back to sign-in options
menu to set up Window Hello
Webcam.
Q16: Why I cannot automatically
switch to the connected input
source after daisy chain over
USB-C?
Ans: It's because your primary monitor
connects to more than one input
source at the same time. When
you use the primary monitor to
the notebook with USB-C, and
also daisy chain to the secondary
monitor.
Once the notebook goes into
standby mode, if you want to
show the content from HDMI or
DisplayPort, please press
change the signal input source.

11.3 Multiview FAQs

Q1:
Ans.: Yes, there are 3 sizes to select:
Q2:
Ans.: Normally the audio source is
Q3:
Ans:
to
40
Can I enlarge the PIP sub
window?
[Small], [Middle], [Large]. You
can press to enter OSD menu.
Select your preferred [PIP Size]
option from the [PIP / PBP] main
menu.
How to listen to Audio,
independent of video?
linked to the main picture source.
If you want to change audio-
source input , you can press
to enter OSD menu. Select your
preferred [Audio Source] option
from the [Audio] main menu.
Please note that the next time you
turn on your display, the display
will by default select the audio
source you chose last time. In case
you want to change it again, you
need to go through the above
steps to select your new preferred
audio source, which then will
become the "default" mode.
Why the sub-windows flickers
when I enable PIP/PBP.
It's because the sub-windows
video source is interlace timing
(i-timing), please change sub-
window signal source to be
progressive timing (P-timing).