Page 8
Remove all packaging and any labels. If the plug or cord is damaged it must, for safety reasons, be replaced by Kenwood or an authorised Kenwood repairer in order to avoid a hazard. DO NOT touch the sharp blades. The blades and discs are very sharp, handle with care.
Page 9
Only use the appliance for its intended domestic use. Kenwood will not accept any liability if the appliance is subject to improper use, or failure to comply with these instructions. Misuse of your processor, blender or mill can result in injury.
Page 10
unripened foods as you may find that some ingredients remain unprocessed. Do not blend frozen ingredients or ice cubes without liquid. Never blend dry ingredients (e.g. spices, nuts) or run the Blender empty. Mill Attachments Never fit the blade assembly to the power unit without the jar/ lid fitted.
If the plug supplied with your appliance has a fuse fitted and the fuse fails it must be replaced with one of the same rating. If the plug or cord requires replacing a new cord set should be fitted by an Authorised Kenwood Repairer. Note: For non-rewireable plugs the fuse cover MUST be refitted when replacing the fuse.
Page 12
Attachments Weighing Function Not all of the attachments listed below may be Illustration included with your food processor. Attachments Your food processor is fitted with a built in are dependent upon the model variant. Refer weighing function to allow ingredients to be to ‘service and customer care’...
Page 13
Using The Attachments Hints and Tips When making mayonnaise, put all the Refer to recommended usage chart ingredients, except the oil, into the blender. for each attachment. Remove the filler cap. Then, with the appliance running, add the oil slowly through Plastic Blender the hole in the lid.
Page 14
Dual Whisk Citrus Juicer (if supplied) Using The Whisk Cone Sieve Fit the drive shaft and bowl onto the power unit. To use the citrus juicer Push each beater securely into the drive head. Fit the drive shaft and bowl onto the power Fit the whisk by carefully turning until it unit.
Page 15
Select maximum speed. Allow the ingredients Grinding Mill (if supplied) to blend until smooth. Once your drink has reached the desired Mill lid consistency, you can use the pulse ‘P’ to Grinding mill blade assembly ensure all ingredients are thoroughly blended. Place your ingredients into the blade assembly.
Use in conjunction with the following: To prevent the food from jamming do not 18-19-20 pack the food tightly in the feed tube – ideally the food should be cut no larger than: 50 X 30mm Important - Dicer and Discs If the food is not exiting the food outlet, switch off and check that food is not clogging under the disc and the slinger plate is fitted.
Recommended Usage Chart Do not operate your appliance for longer than the times specified below without a rest period. Do not exceed the maximum capacities stated in the chart below. Processing continuously for longer periods can damage your appliance. Processing information supplied is for guidance only and will vary depending on the exact recipe and ingredients being processed.
Troubleshooting Guide Problem Cause Solution The processor will not No Power. Check processor is plugged in. operate. Bowl not fitted to power Check bowl is located correctly and the unit correctly. handle is situated towards the right front hand corner. Bowl lid not locked on Check that the lid interlock is located correctly.