Page 1
Installation manual PV Solar MODULE Please read this manual carefully before operating your set and retain it for future reference. N-TYPE MODELS LGXXXQ1C-A6 LGXXXQ1K-A6 www.lg.com/global/business/solar...
SAFETY The instructions related to the safety indicated in the Do not approach the damaged following are for preventing unexpected danger or or broken module unless you are damage in advance by safely and exactly using the product. an authorized or qualified expert. Failure to comply may result in DANGER serious bodily injury or death.
Page 4
Installation during rain, heavy Module wind or snowy day may result in Module Installing structure bodily injury or death. Installing structure (Stralght type) (bent type) Holes in the frame or glass of the module may decrease the strength of the frame or break the glass.
BEFORE & AFTER INSTALLATION Before Installation • Be careful not to damage the cable when using a tool Please carefully read this manual before installation. such as a knife to remove the cable tie that fixes the • Solar module installation and maintenance must be junction box cable.
Diodes properties or physical configurations in the same system. • All LG modules are equipped with factory installed • Match the polarities of cables and terminals when bypass diodes. The factory-installed diodes provide making the connections; failure to do so may result in proper circuit protection for the module from damage to the panel.
PV must be done on the frames of solar modules and arrays output. although the solar modules from LG meet the conditions of • Depending on national directives, additional safety safety class II. The national directives must be respected.
Excluded Operating Environments faces the sun directly. The tilt angle of the modules • The solar modules from LG Electronics can not be should be selected to optimize seasonal and sunlight operated in a location where they could come in direct -based performance in the installation place.
Page 9
• The solar module may be mounted by using the Mounting by using clamps following methods: (*Torque:8~12N∙m) • The module may be fastened to a support by using When installing modules in heavy snow areas, clamps on both the long edge and the short edge of •...
Disclaimer of Liability • By beginning to installation process, the installer has to read and completely understand this Installation Manual. • If installer had any questions regarding this installation manual, the installer would have contacted LG with any questions or concerns.
Fig 6. Clamping Type Position Load Position Load (mm) Front/Rear(Pa) (mm) Front/Rear(Pa) 0~300 2400/2155 0 ~ 300 5400/2155 820~920 5400/4000 Note) All mechanical installation methods and bolting method in this appendix were not tested by VDE. It is evaluated by LG internal test.
Fig 10. Clamping Type Position Load Position Load (mm) Front/Rear(Pa) (mm) Front/Rear(Pa) 0~300 200~400 2400/2155 2155/2155 200~400 0~300 Note) All mechanical installation methods and bolting method in this appendix were not tested by VDE. It is evaluated by LG internal test.
Page 15
Height • Follow the clamp manufacturer’s recommended applied torque to fasten the clamps. • Depth <Edge Clamp> Note) All mechanical installation methods and bolting method in this appendix were not tested by VDE. It is evaluated by LG internal test.
Unloading Flow Guide If you are unloading using heavy equipment such as a crane, please follow the procedure below. [ Step 1 ] [ Step 2 ] [ Step 3 ] [ Step 4 ] Step 1. Place the packaging on a flat surface. Step 2.
Page 17
Seoul 07336, Korea Contact: solar-svc@lge.com http://www.lg-solar.com This document is subject to change without notice. LG, LG logo and Life's Good are trademarks of LG Electronics, Inc. worldwide. Trademarks and intellectual properties of LG Electronics, Inc. are protected by international copyright laws.