Page 3
1. Precaution Please read the precaution as follows to prevent any damages to the LCD Monitor. Make sure all power connector is removed. Be sure that the LCD Monitor is in power off status. Prepare soft cloth and sponge as working platform to place LCD monitor horizontally.
Page 4
2. Appropriate tools Select the Appropriate tools for disassembly and re-assembly. Phillips screwdriver (#2) C/D disassembly tool Gloves or soft cloth...
Page 5
3. Disassembly SOP Put the monitor on a flat surface (Put the EPE on under the monitor) Depress the release button to pull out the stand base Remove the screw * 4pcs Tool : Screwdriver #2 Use the C/D disassembly tool to release rear cover hook from disassemble hole on bottom...
Page 6
Wedge fingers between the rear cover and the middle frame as the arrow direction shown for unlocking the mechanisms Remove all tape and foil Remove 8pcs screws for unlocking the middle frame. Tool : Screwdriver #2 Unplug light bar wire and LVDS wire...
Page 7
Unplug the keypad cable, then release the middle frame from the Panel Release the keypad PCB from the middle frame Release the cables from hook of bracket Take out the mylar sheet from Main chassis...
Page 8
Remove all screw. Tool : Screwdriver #2 Take out PCB and peel off all mylar. Take out the thermal pads from power PCB...