Table of Contents
Advertisement
> troubleshooting the Gateway
4. Selecting the Properties , you can see networking protocol and then click Internet
Protocol version 4 (tCP/IPv4).
figure 5.3 Wireless network Protocol Setup Window
reset/restore the Gateway via the reSet button in rear Panel
To reset the Gateway to factory defaults, you should press and hole the RESET button on the
rear panel of Gateway for more five or seconds. You can also need to do this if a
misconfigurations ha locaked out all access.
1. Make sure that the Gateway is turned on.
2. If you want to:
• Reset the Gateway, use a pen or an unfolded paperclip to push the recessed Reset button on
the back panel of the Gateway for approximately 5~10 seconds and then release it.
• Restore the factory default settings of the Gateway, use a pen or an unfolded paperclip to
push the recessed Reset button on the back panel of the Gateway for at least 10 seconds and
then release it.
3. The Gateway can restart.
ENG - 37
Advertisement
Table of Contents
