Table of Contents
Advertisement
Pressing the reset button for less than 10 seconds during normal operation will toggle the LED mode
between "normal" (default after power on) and "off" mode.
Pressing the reset button for longer than 10 seconds may cause the access point to reset and return to the factory
default state.
Primary DC Power Port (Circular)
This DC power port is designed for use with the power adapter (part number R9D91A) included in the
package.
After inserting the L-shape DC connector of the power adapter into the DC power port, rotate the
DC connector by 90 degrees and route the power cord through the cable hook on the access point. See
Figure 4
and
Figure
Figure 4 Connecting Power Adapter to DC Power Port
Figure 5 Routing Power Cord through Cable Hook
Alternate DC Power Port (USB-C)
The USB-C port is designed to offer an alternate way to provide DC power to the AP-503R access point by
using a compatible 5V/3A USB-C power adapter.
Ethernet Ports
The AP-503R access point has three Ethernet ports (E0 - E2), shown in
4
|
5.
Figure
2.
Rev 02|May 2023
Advertisement
Table of Contents
