Philips FC6840 Series Manual
Hide thumbs Also See for FC6840 Series:

Advertisement

Quick Links

FC6840 series

Advertisement

Table of Contents
loading

Summary of Contents for Philips FC6840 Series

  • Page 1 FC6840 series...
  • Page 4 English introduction Congratulations on your purchase and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. general description (Fig. 1) a Dry use 1 Hose connector 2 Suction hose 3 Mechanical suction power control...
  • Page 5: Electromagnetic Fields (Emf)

    Do not use the appliance if the plug, the mains cord or the appliance itself is damaged. If the mains cord is damaged, you must have it replaced by Philips, a service centre authorised by Philips or similarly qualified persons in order to avoid a hazard.
  • Page 6: Preparing For Use

    English Preparing for use Connecting and disconnecting accessories hose To connect the hose, insert it into the hose connector while you turn it clockwise a little (Fig. 2). To disconnect the hose, pull it out of the hose connector while you turn it anticlockwise a little (Fig.
  • Page 7: Preparing For Vacuuming Liquids

    English Slide the holder with dustbag into the appliance in such a way that the holder is kept in place by the two ridges in the container (Fig. 17). Put the motor unit back into the container and close the clamps (‘click’). (Fig. 18) Put the micro filter into place (specific types only) (Fig.
  • Page 8: Using The Appliance

    English Fasten the long shampoo hose to the suction hose and suction tube with the shampoo hose clips (Fig. 32). Attach the double-injection nozzle (Fig. 6). The appliance is now ready for shampooing soft floors, such as carpets and rugs. using the appliance Pull the mains cord out of the appliance and insert the mains plug into the wall socket (Fig.
  • Page 9: Carpet Shampooing Tips

    English If the carpet (or part of it) merely requires freshening up, you do not need to apply a lot of shampoo. It is probably sufficient to only apply shampoo when you make the first stroke towards you. Then release the trigger and move the nozzle over the cleaned area a few times without applying shampoo.
  • Page 10: Shampooing Furniture

    English To remove shampoo effectively, make overlapping strokes and finish off with one stroke across as shown in the figure. (Fig. 44) After shampooing, release the trigger and press the shampoo pump on/off button to switch off the pump. Keep the appliance itself switched on (Fig. 38). Lift the nozzle off the floor.
  • Page 11: Motor Protection Filter

    Press and hold the red lever to release the cardboard front of the dustbag (Fig. 53). Throw away the full dustbag and insert a new one (see chapter ‘Preparing for use’). Note: A new motor protection filter and a new micro filter are provided with each set of original Philips Athena paper dustbags.
  • Page 12: Micro Filter (Specific Types Only)

    English Never use the appliance without the motor protection filter. Micro filter (specific types only) When you vacuum dry substances, the electrostatic micro filter purifies the exhaust air by removing minuscule dust particles. The effectiveness of the filter decreases gradually during use. Normally it suffices to replace the micro filter when you insert the first of a new set of paper dustbags.
  • Page 13: Guarantee And Service

    If you need service or information or if you have a problem, please visit the Philips website at www.philips.com or contact the Philips Consumer Care Centre in your country (you find its phone number in the worldwide guarantee leaflet). If there is no Consumer Care Centre in your country,...

Table of Contents