Table of Contents
Advertisement
AS700GB
11/24/04 10:53 AM
Setting the Speaker
• F.SPK (Front) : LARGE, SMALL
• C.SPK (Center) : LARGE, SMALL, NONE
• S.SPK (Rear) : LARGE, SMALL, NONE
• SB SPK (Rear Center) : LARGE, SMALL, NONE
• SW SPK (Subwoofer) : YES, NO
• CROVR (Crossover Frequency): 40, 60, 80, 100, 120, 150,200Hz
Page 18
MAIN UNIT
1
Press and hold SURROUND button for about 5 seconds.
• "SETUP MODE" appears on the display and enters into Setup Mode.
2
Press INPUT button one time.
• "SPEAKER SETUP" appears in the display.
Press SURROUND button to select the speaker you want.
3
Each time you press this button, F.SPK
SPK SW SPK
4
Press SELECT (
Repeat the steps 3 and 4 to set the speaker.
5
To Exit Setup Mode
Wait for about 5 seconds or turn the VOLUME CONTROL of the main unit.
•
"SETUP MODE OFF" appears on the display and exits Setup Mode.
CROVR will be selected in turn.
) button to set the speaker as you want.
,
• LARGE : Select when you use large speaker. You can listen to full
ranges of sound from bass to treble.
• SMALL : Select this when you use small speaker. Bass below
100ß' will not be output from the whole speakers but only
from subwoofer.
• NONE : Select this when you use no speaker.
• YES : Select this when you use Subwoofer Speaker if you play
back in 2 Channel Stereo.
• NO : Select when you do not use Subwoofer Speaker if you play
back in 2 Channel Stereo.
• CROVR: Select the crossover frequency depending on the size of
speaker connected when you use subwoofer. Select 40Hz
if cone paper speaker is 16cm, select 60Hz for 14cm,
80Hz for 12cm, 100Hz for 10cm, 12Hz for 8cm ,150Hz for
6cm and 200Hz for 4cm.
C.SPK
S.SPK
SB
18
Advertisement
Table of Contents
