Pair Tracker And Router - Honeywell FFP21996 User Manual

USE AND OPERATION (CONTINUED)
Connect Tracker and Router to App (continued)
Common Trouble Shooting:
1. Make sure your tracker subscription is activated.
2. Make sure your tracker is in a flashing state, when attached to the router it
should an alternating flashing between two different colors, blue and green
or blue and yellow. After the device is turned on, it needs to be connected within
5 minutes or it will automatically turn off. Turn the device back on and try the
connection again.
3. If the devices are still not found in the app, please try to reset them. To reset
the tracker, connect it to your plugged in Router/Charging Dock (the Tracker
must be connected to the Router to reset properly), press and hold the power
button for 30s until the yellow light stops flashing. The tracker will beep when
the reset has begun, please wait 2 minutes for the device to fully reset. After
resetting, the Tracker will be deleted by the App. To reset the tracker router,
connect the router (with GPS attached) to a power outlet for 2-3 seconds and
then unplug it for 2-3 seconds. Repeat this 5 times to complete the reset.
4. If the tracker and router connections timeout and fail to add, make sure
your cell phone is connected to Wi-Fi and the connection is available. Reset
the devices if needed.

Pair Tracker and Router

1. On your App Home Screen, tap the Tracker Router under your list of "All
Devices" to enter the association interface (see next page for picture 1).
2. Tap "+Add device by list" at the bottom of the screen to be taken to a list of
all your connected devices (see next page for picture 2).
3. Select your tracker, then click "Confirm", then confirm the pop-up prompt
to pair your tracker with your tracker router. The tracker and router pairing will
improve the product quality.
EN 12